Adjusting the Pro suspension
Last updated November 3, 2026
Front Suspension
The front suspension on the Pro has both a spring and a dampener system.
The dampener can be adjusted by turning the red knob clockwise or counterclockwise.
Clockwise: Reduces the rebound force
Counter-Clockwise: Increases the rebound force
The spring can be adjusted by turning the lower spring disk clockwise and counterclockwise
Clockwise: Tighten
Counter-Clockwise: Loosen
Tool: 3/4" spanner wrench. This set of tools can be used to adjust the Pro front suspension: https://www.amazon.ca/Gardner-Bender-LNW-KIT-Innovative-Construction/dp/B018N80XLQ/ref=sr_1_14?keywords=3%2F4%2Bspanner%2Bwrench&qid=1692283091&refinements=p_85%3A5690392011&rnid=5690384011&rps=1&sr=8-14&th=1
Rear Suspension
The rear suspension is made of a rubber block.
The rear suspension should not be tightened too much. It should be tightened just enough so that the rear swingarm does not fall when the rear of the scooter is lifted.
To adjust the rear suspension the six grub screws at the bottom need to be adjusted. To tighten the rear suspension turn the grub screw
Tool: 5mm allen key
Clockwise: Tighten
Counter-Clockwise: Loosen
Do not over-tighten the rear suspension: it should hold the swingarm in place, no tighter.
